classic analog rigs Thorens, Garrard, Lenco, EMT, etc..
Moderators: setup1, setup2
by diego » Thu Oct 29, 2009 10:40 am
How can I remove the sub platter on the TD 160 super? Is there a lock? Correct me if I am wrong, to access the bearing (which I plan to clean and oil ) I have to remove the sub platter. Been trying to pull it up but there seems to be a lock which prevents full removal. Thank you for any help.
-
diego
- Citizen
-
- Posts: 147
- Joined: Tue Oct 12, 2004 11:33 am
by hypertriode » Thu Oct 29, 2009 12:08 pm
diego wrote:How can I remove the sub platter on the TD 160 super? Is there a lock? Correct me if I am wrong, to access the bearing (which I plan to clean and oil ) I have to remove the sub platter. Been trying to pull it up but there seems to be a lock which prevents full removal. Thank you for any help.
Yes there's a lock and you need to open the bottom cover to gain access to the screw that attaches the lock assembly to the plinth
-
hypertriode
- Grand Master
-
- Posts: 4433
- Joined: Tue Jan 28, 2003 9:15 pm
by diego » Thu Oct 29, 2009 3:42 pm
Where is the unlocking screw located? Don't want to make the mistake of removing the wrong screw. If only I were in Manila, I would let the professionals do this. Thank you hyper.
-
diego
- Citizen
-
- Posts: 147
- Joined: Tue Oct 12, 2004 11:33 am
by hypertriode » Thu Oct 29, 2009 4:11 pm
diego wrote:Where is the unlocking screw located? Don't want to make the mistake of removing the wrong screw. If only I were in Manila, I would let the professionals do this. Thank you hyper.
near the bearing shaft bro
-
hypertriode
- Grand Master
-
- Posts: 4433
- Joined: Tue Jan 28, 2003 9:15 pm
Return to IDLER TURNTABLES
Who is online
Users browsing this forum: No registered users and 11 guests