Hello:
Just wanna share my "attempt" to upgrade the plinth of my L78. Used the template for an L75 as reference to the 6 layer cut-outs and stack 'em up. I don't have the tools to make the layered plinth so i went to a woodworking shop near our place and gave instruction to the craftsman.MDF was the material used on the plinth. There are still modification that needed to be done in the plinth to make the l78 sit properly in the l75 template inspired plinth.
The real challenge will start when i disassemble all the lenco parts and put it all in the new plinth. I've been lurking to other websites to get some ideas and information on projects like this, I'm not much of a DIYer but i'm hoping to pull this one off. I once replaced a busted light bulb naman e. hehe..
Some pictures of the plinth mga sir:
Also planning to replace all interconnects and power cable of the table.Pag di ko na kinaya pede bang maka pagtanong sa mga masters?
Salamat po!
Pau